2013 Volkswagen Jetta – Keyless Entry Remote Fob Programming Guide

Important Notice: The 2013 Volkswagen Jetta is equipped with a smart key system that does not support onboard programming. Any new or replacement smart key remote fob must be programmed using specialized diagnostic equipment capable of interfacing with the vehicle’s immobilizer and electronic access systems. Programming Requirements: One or more unprogrammed smart key remote fobs compatible with the 2013 system Vehicle-specific diagnostic equipment with key programming capabilities All existing smart keys present at the time of programming (if applicable) Proof of vehicle ownership may be required for authorization

Programming Procedure:

• Step 1: Ensure the vehicle is parked securely with the ignition turned off. Gather all current and new smart keys before beginning the process.
• Step 2: Connect an appropriate diagnostic device to the vehicle’s OBD-II port, located beneath the dashboard on the driver’s side.
• Step 3: Access the vehicle's electronic control modules via the diagnostic interface and navigate to the smart key or immobilizer programming menu.
• Step 4: Follow the tool’s on-screen prompts to initiate the pairing process. This may include holding the new smart key near the push-to-start button, inserting it into a reader slot, or performing proximity-based verification steps.
• Step 5: Once the system identifies the new key, proceed with the registration. If multiple keys are being added, each one must be programmed within the same session to avoid removal of previously registered remotes.
• Step 6: Upon successful programming, the diagnostic tool will confirm the completion of the process. All programmed smart keys should now be fully functional.
• Step 7: Test each key to ensure proper operation of all functions, including engine start, door lock/unlock, and proximity detection (if equipped).
• Step 8: Disconnect the diagnostic equipment and verify that the vehicle starts and responds appropriately to each key.