<h1>2014 Audi TT Keyless Entry Remote Fob (Smart Key)</h1> <p><font size="3"><b>Important:</b> The 2014 Audi TT does not support on-board programming for smart key remote fobs. Programming requires specialized diagnostic tools capable of accessing the vehicle's immobilizer system. </font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b></font></p> <ul> <li><font size="3"> Step 1: Confirm Fob Compatibility Ensure that the replacement remote fob is compatible with the 2014 Audi TT and has not been previously programmed to another vehicle. </font></li> <li><font size="3">Step 2: Prepare the Vehicle Shift the vehicle into Park and turn off the ignition. Ensure all doors are closed. Check that both the vehicle and remote fob batteries are fully charged. </font></li> <li><font size="3">Step 3: Connect Diagnostic Equipment Plug Audi-compatible diagnostic software (e.g., ODIS, VCDS/VAG-COM) into the vehicle’s OBD-II port, located beneath the dashboard. Power on the diagnostic interface and launch the software. </font></li> <li><font size="3">Step 4: Access Immobilizer and Key Programming Menu Navigate to the Immobilizer (IMMO) or Key Learning module within the software. Enter the PIN/SKC code when prompted (this code is required to authorize key programming). </font></li> <li><font size="3">Step 5: Register the New Smart Key Follow the on-screen prompts to register the new smart key. If additional keys need to be programmed, they must be done at this time. All existing remotes will typically need to be present. </font></li> <li><font size="3">Step 6: Confirm Programming Success Upon successful pairing, the system will display a confirmation. If pairing fails, verify compatibility and repeat the process starting from Step 3. </font></li> <li><font size="3">Step 7: Test All Functions Check the following functions: Lock/Unlock doors Trunk release Panic button (if available) Push-to-start ignition function (if equipped) </font></li> <li><font size="3">Step 8: Program Additional Remotes (If Needed) Repeat Step 5 for each remote you wish to add. Up to 8 keys may be supported depending on the vehicle’s configuration. </font></li> <li><font size="3">Step 9: Exit Programming Mode Close the programming session in the software. Disconnect the diagnostic equipment from the vehicle.</font></li> </ul> <p><font size="3"><b> Additional Notes:</b> </font></p> <p><font size="3">All steps must be completed promptly to stay within the allowed programming time window. Using fully charged batteries in both the vehicle and fob is essential. These instructions apply only to the remote functionality. Separate procedures and equipment are needed to cut and program the transponder portion (if applicable).</font></p>
