2015 Cadillac SRX

Programming Guide for 2015 Smart Keyless Entry Remote Fob – Cadillac SRX

Important Notice: The 2015 Cadillac SRX, equipped with Keyless Access, allows onboard programming of remote fobs. Programming methods differ based on whether at least one functioning remote is available. Follow the appropriate procedure below.

Programming with a Recognized Remote Fob: If at least one working remote is available, use this method to program additional fobs.

  • Step 1: Ensure the vehicle is completely off and have both the working and new remote(s) inside the vehicle.
  • Step 2: Place the recognized remote in the front cupholder for identification.
  • Step 3: Remove the mechanical key from the new transmitter and insert it into the driver’s side door lock.
  • Step 4: Turn the key to the unlock position five times within ten seconds.
  • Step 5: The Driver Information Center (DIC) will display READY TO LEARN ELECTRONIC KEY #2, 3, 4, etc.
  • Step 6: Open the center console, lift the storage tray, and locate the transmitter pocket.
  • Step 7: Insert the new remote into the pocket with the buttons facing forward.
  • Step 8: Press the ignition button (do not start the engine). The DIC will confirm that the remote has been learned.
  • Step 9: Remove the remote from the pocket and press Unlock or Lock to verify functionality.
  • Step 10: To program additional remotes, repeat Steps 7 through 9 for each one.
  • Step 11: Once finished, press and hold the ignition button for 12 seconds to exit programming mode.
  • Step 12: Confirm operation of all programmed remotes by testing the lock and unlock buttons.

Programming without a Recognized Remote Fob: If no working remotes are currently available, follow this method. This method is not supported in Canada. Estimated duration: 30 minutes

  • Step 1: With the vehicle turned off, insert the mechanical key into the driver door lock.
  • Step 2: Turn the key to the unlock position five times within ten seconds.
  • Step 3: The DIC will show REMOTE LEARN PENDING, PLEASE WAIT.
  • Step 4: Wait approximately 10 minutes. The DIC will then display PRESS ENGINE START BUTTON TO LEARN.
  • Step 5: Press the ignition button once. The DIC will return to REMOTE LEARN PENDING, PLEASE WAIT.
  • Step 6: Repeat Step 5 two more times. After the third cycle, all previous remotes will be erased.
  • Step 7: The DIC will now display READY FOR REMOTE #1.
  • Step 8: Open the center console, lift the tray, and place the new transmitter into the transmitter pocket, with buttons facing forward.
  • Step 9: Press the ignition button again. When recognized, the DIC will confirm readiness to program the next remote.
  • Step 10: Remove the remote and press Unlock or Lock to complete pairing.
  • Step 11: To program additional transmitters, repeat Steps 8 through 10.
  • Step 12: Once all remotes are paired, press and hold the ignition button for 12 seconds to finalize and exit programming mode.
  • Step 13: Test each remote to confirm successful programming.