2015 Mitsubishi Outlander

2015 Mitsubishi Outlander – Remote Fob & Smart Key Programming Guide

Standard Key / Remote Head Key – Immobilizer (Engine Start) Programming

Note: This method is not supported on vehicles sold in Canada. You must have two already programmed keys to register a third. This process only programs the ignition/start function. Remote buttons on Remote Head Keys are programmed separately.

  • Step 1: Insert the first programmed key into the ignition. Turn it to the ON position for 5 seconds, then turn it to LOCK and remove it.
  • Step 2: Within 30 seconds, insert the second programmed key and turn it to the ON position.
  • Step 3: After about 10 seconds, the immobilizer warning light will begin to blink.
  • Step 4: Once the light starts blinking, turn the key to LOCK and remove it.
  • Step 5: Within 30 seconds, insert the new unprogrammed key, turn it to the ON position, and wait. If the immobilizer light turns on for 3 seconds and then turns off, programming is successful. If the light goes off early or behaves abnormally, restart the procedure.
  • Step 6: Test the new key to confirm it starts the engine.
  • Step 7: Repeat from Step 1 for any additional keys. Remote Head Key – Remote Lock/Unlock Button Programming This procedure programs the button functions of a Remote Head Key.

One working remote is required to begin.

  • Step 1: Prepare all remotes to be programmed. Any remotes not programmed during this session will no longer function.
  • Step 2: On a working remote, press and hold the UNLOCK button for 4 to 10 seconds, then press and hold the LOCK button.
  • Step 3: Within 10 seconds, release the LOCK button first, then the UNLOCK button. The vehicle will lock and unlock the doors to confirm programming mode is active.
  • Step 4: Within 60 seconds, for each remote to be programmed: Press and hold LOCK and UNLOCK simultaneously for 2 seconds Release both for 1 second Press and release UNLOCK
  • Step 5: The doors will cycle to confirm each remote was programmed successfully.
  • Step 6: Repeat Step 4 for each additional remote. The vehicle will exit programming mode if no new remotes are added within 60 seconds.
  • Step 7: Test all programmed remotes to ensure they work properly. Smart Key System – Full Smart Key and Remote Programming This section applies to vehicles with a Smart Key system. To program a new Smart Key, you must have two programmed Smart Keys.

The steps below handle both engine start registration and button function programming. Smart Key Programming Procedure

  • Step 1: Open the driver’s door and leave it open for the duration of the procedure. Do not operate any other doors.
  • Step 2: With the first programmed Smart Key, turn the ignition to ON (do not start the engine). Proceed within 30 seconds.
  • Step 3: Insert the new Smart Key into the designated key slot in the correct direction.
  • Step 4: Using the first Smart Key, press and hold the UNLOCK button for 4 to 10 seconds, then press and hold the LOCK button.
  • Step 5: Release the LOCK, then UNLOCK buttons in sequence within 10 seconds of pressing LOCK.
  • Step 6: With the second programmed Smart Key, press and hold the UNLOCK button for 4 to 10 seconds, then press and hold the LOCK button.
  • Step 7: Again, release LOCK, then UNLOCK. The immobilizer indicator on the multi-information display will begin blinking. When programming is complete, the buzzer will sound three times, and the immobilizer light will remain on for 30 seconds. If an error occurs, the buzzer will sound for 3 seconds, and programming will be canceled.
  • Step 8: If you wish to register another Smart Key, turn the ignition OFF, remove the new key from the slot, and repeat from Step 1.