2016 Lincoln MKX

Programming a Smart Key Remote for 2016 Lincoln MKX

Important: This process allows for the programming of an additional smart key using the vehicle’s onboard system. It requires two existing, programmed smart keys. The system supports a maximum of four smart keys. If fewer than two valid keys are available, this procedure cannot be completed manually. The ignition must remain off during key transitions. All doors must stay closed throughout the entire procedure. Read all instructions before beginning. Perform each step in the correct order. If interrupted or performed incorrectly, wait 10 seconds before starting over.

Smart Key Programming Steps:

  • Step 1: Ensure the vehicle is turned off and all doors are securely closed.
  • Step 2: Open the lid of the center floor console storage compartment.
  • Step 3: Locate the backup slot inside the compartment.
  • Step 4: Insert the first programmed smart key into the slot with the buttons facing the rear of the vehicle and the key ring facing upward.
  • Step 5: Press the push-button ignition once (without pressing the brake pedal).
  • Step 6: Wait approximately five seconds.
  • Step 7: Press the ignition button again to turn the system off.
  • Step 8: Remove the first smart key from the slot.
  • Step 9: Within 10 seconds, insert the second programmed smart key into the same slot in the same orientation.
  • Step 10: Press the ignition button once again.
  • Step 11: Wait five seconds, then press the ignition button again to turn the vehicle off.
  • Step 12: Remove the second smart key from the slot.
  • Step 13: Wait five additional seconds, then insert the new, unprogrammed smart key into the slot.
  • Step 14: Press the ignition button once. If the key is successfully recognized, it will be programmed to the vehicle.
  • Step 15: Remove the newly programmed key from the slot.
  • Step 16: Test the new smart key by using it to lock and unlock the doors.
  • Step 17: Start the vehicle using the newly added smart key to verify that programming was successful.
  • Step 18: If the process fails, wait 10 seconds, then repeat steps 1 through 17 from the beginning.