2017 Cadillac XTS

Programming Guide for 2017 Cadillac XTS Smart Keyless Entry Remote Fob

Importance: Programming your 2017 Cadillac XTS keyless entry remote fob ensures your new transmitter works seamlessly with your vehicle’s security and ignition systems. This procedure is necessary when replacing lost remotes or adding additional ones for other drivers. The following steps outline new remote both when two recognized remotes are available and when no working remotes are present.

Programming with Two Recognized Transmitters:

  • Step 1: Remove the physical vehicle key from one of the recognized transmitters.
  • Step 2: Place both recognized transmitters inside the front center console cupholders.
  • Step 3: Remove the key lock cylinder cap on the driver door handle. Insert the vehicle key and turn it counterclockwise to the unlock position five times within 10 seconds. The Driver Information Center (DIC) will display “READY FOR REMOTE #2, 3, 4, ETC.”
  • Step 4: Place the new transmitter in the transmitter pocket located inside the center console storage area between the front seats. Lift the storage tray to access the pocket.
  • Step 5: Press the ENGINE START/STOP button. When the remote is successfully programmed, the DIC will confirm readiness for the next transmitter.
  • Step 6: Remove the transmitter from the pocket and press the lock or unlock button on the fob. To program additional remotes, repeat Steps 4 through 6 for each transmitter.
  • Step 7: When all transmitters are programmed, press and hold the ENGINE START/STOP button for approximately 12 seconds to exit programming mode.

Programming Without a Recognized Transmitter:

  • Step 1: Remove the key lock cylinder cap on the driver door handle. Insert the key and turn it counterclockwise to the unlock position five times within 10 seconds. The DIC will display “REMOTE LEARN PENDING, PLEASE WAIT.”
  • Step 2: Wait for 10 minutes until the DIC displays “PRESS ENGINE START BUTTON TO LEARN,” then press the ENGINE START/STOP button.
  • Step 3: Repeat Step 2 two more times for a total of three cycles (approximately 30 minutes). After the third cycle, the DIC will display “READY FOR REMOTE #1.” At this point, all previous remotes are erased.
  • Step 4: Place the new transmitter in the transmitter pocket located inside the center console. Ensure the buttons face the rear of the vehicle.
  • Step 5: Press the ENGINE START/STOP button. The DIC will confirm when the transmitter is learned.
  • Step 6: Remove the transmitter and press the lock or unlock button to finalize pairing. Repeat Steps 4 through 6 for each additional remote you wish to program.
  • Step 7: Press and hold the ENGINE START/STOP button for about 12 seconds to exit programming mode.