2018 Buick Enclave

2018 Smart Keyless Entry Remote Fob

Programming with Two Working Remotes:This method is used when two remotes are already programmed to the vehicle. The process allows you to add one or more additional remotes.

  • Step 1: Ensure the vehicle is turned off and all remotes are nearby.
  • Step 2: Place both currently working remotes in the front cupholder.
  • Step 3: Locate the key lock cylinder on the exterior driver’s door handle.
  • Step 4: Remove the protective cap covering the key cylinder.
  • Step 5: Take the new remote’s emergency key and insert it into the exposed key cylinder.
  • Step 6: Turn the key to the unlock position (counterclockwise) five times within 10 seconds.
  • Step 7: Check the dashboard display; it should show “READY FOR REMOTE #3,” “#4,” or “#5.”
  • Step 8: Open the center console, lift out the upper tray and rubber mat to access the remote pocket.
  • Step 9: Place the new remote into the pocket.
  • Step 10: Press the ENGINE START/STOP button once.
  • Step 11: Wait for the system to confirm the remote has been learned.
  • Step 12: Remove the remote from the pocket.
  • Step 13: Press either the LOCK or UNLOCK button to finalize pairing.
  • Step 14: To program more remotes, repeat Steps 9 through 13.
  • Step 15: When done, press and hold the ENGINE START/STOP button for 12 seconds to exit programming mode.
  • Step 16: Reinsert the key into the remote and replace the key cylinder cap on the door.

Programming Without Any Recognized Remotes: If no remote is currently programmed, use this method to program up to eight new remotes. The process takes approximately 30 minutes to complete.

  • Step 1: Confirm that all remotes to be programmed are present.
  • Step 2: Ensure the vehicle is turned off and all doors are closed.
  • Step 3: Remove the key lock cylinder cap from the outside of the driver’s door.
  • Step 4: Insert the emergency key from one of the new remotes into the door lock.
  • Step 5: Turn the key to the unlock position (counterclockwise) five times within 10 seconds.
  • Step 6: The display will show: “REMOTE LEARN PENDING, PLEASE WAIT.”
  • Step 7: Do not press anything. Wait approximately 10 minutes.
  • Step 8: When prompted, press the ENGINE START/STOP button.
  • Step 9: The system will again display: “REMOTE LEARN PENDING, PLEASE WAIT.”
  • Step 10: Repeat Steps 5 through 9 two more times (for a total of three 10-minute cycles).
  • Step 11: After the third cycle, the display will show: “READY FOR REMOTE #1.”
  • Step 12: Open the center console, remove the tray and rubber mat to reveal the remote pocket.
  • Step 13: Place the first new remote into the pocket.
  • Step 14: Press the ENGINE START/STOP button.
  • Step 15: Wait for confirmation that the remote has been learned.
  • Step 16: Remove the remote and press LOCK or UNLOCK to complete the process.
  • Step 17: Repeat Steps 13 through 16 for any additional remotes.
  • Step 18: After all remotes are programmed, press and hold the ENGINE START/STOP button for 12 seconds to exit.
  • Step 19: Insert the key back into each remote.
  • Step 20: Reinstall the cap on the driver’s door lock.