2018 Buick Envision

2018 Smart Keyless Entry Remote Fob – Envision

Programming with Two Recognized Transmitters: Use this method when two working remote fobs are already paired with the vehicle. This procedure allows you to add additional transmitters without special tools.

  • Step 1: Confirm the vehicle is turned off and parked safely.
  • Step 2: Place both recognized transmitters into the front cupholder inside the vehicle.
  • Step 3: Remove the cap covering the key lock cylinder on the driver’s side exterior door handle.
  • Step 4: Insert the emergency key from the new transmitter into the lock cylinder.
  • Step 5: Turn the key to the unlock position (counterclockwise) five times within 10 seconds.
  • Step 6: The Driver Information Center (DIC) will display: “READY FOR REMOTE #2,” “#3,” “#4,” or “#5.”
  • Step 7: Place the new transmitter into the front cupholder.
  • Step 8: Press the ENGINE START/STOP button once.
  • Step 9: Wait for confirmation that the transmitter has been successfully programmed.
  • Step 10: Remove the transmitter from the cupholder and press the UNLOCK button to complete pairing.
  • Step 11: To add more remotes, repeat Steps 7 through 10 for each additional transmitter.
  • Step 12: Once all transmitters are programmed, press and hold the ENGINE START/STOP button for 12 seconds to exit programming mode.

Programming Without Two Recognized Transmitters: Use this procedure when no functional remotes are available. It allows programming of up to eight transmitters and takes approximately 30 minutes to complete. This method may not be supported in all regions.

  • Step 1: Insert the emergency key into the driver's side door lock cylinder.
  • Step 2: Turn the key to the unlock position (counterclockwise) five times within 10 seconds.
  • Step 3: The DIC will display: “REMOTE LEARN PENDING, PLEASE WAIT.”
  • Step 4: Wait 10 minutes without interacting with the vehicle.
  • Step 5: When prompted, press the ENGINE START/STOP button once.
  • Step 6: The DIC will again display: “REMOTE LEARN PENDING, PLEASE WAIT.”
  • Step 7: Repeat Steps 4 through 6 two additional times, for a total of three 10-minute cycles.
  • Step 8: After the third cycle, the DIC should show: “READY FOR REMOTE #1.”
  • Step 9: Place the new transmitter into the front cupholder.
  • Step 10: Press the ENGINE START/STOP button once.
  • Step 11: Wait for confirmation that the transmitter has been accepted.
  • Step 12: Remove the transmitter and press UNLOCK to complete the process.
  • Step 13: Repeat Steps 9 through 12 for each additional transmitter.
  • Step 14: When programming is complete, press and hold the ENGINE START/STOP button for 12 seconds to exit programming mode.