<h1>2019 Lincoln MKC Smart Key Remote Fob</h1> <p><font size="3"><b>Important:</b> You can program up to four intelligent access keys to your 2019 Lincoln MKC. To complete this process on your own, you must have two valid, previously programmed smart keys. If you have only one or no working keys, programming must be performed by a qualified technician using specialized equipment. Before you begin: Ensure the vehicle is off. Do not press the brake pedal during the procedure unless instructed. All doors must be closed and remain closed during the entire process. Perform all steps within 30 seconds of starting. If any step is performed incorrectly or out of order, wait at least one minute before restarting. </font></p> <p><font size="3"><b>Step-by-Step Smart Key Programming Procedure:</b> </font></p> <ul> <li><font size="3">Step 1: Sit in the driver's seat and make sure the vehicle is completely off. Ensure all doors are closed. </font></li> <li><font size="3">Step 2: Open the center console lid to access the backup slot, typically located inside or at the bottom of the console. </font></li> <li><font size="3">Step 3: Insert the first programmed smart key into the backup slot, with the buttons facing up. </font></li> <li><font size="3">Step 4: Without pressing the brake, press the START/STOP button once to turn on accessory mode. </font></li> <li><font size="3">Step 5: Wait five seconds, then press the START/STOP button again to power off. </font></li> <li><font size="3">Step 6: Remove the first smart key from the slot. </font></li> <li><font size="3">Step 7: Within 10 seconds, insert the second programmed smart key into the same backup slot. </font></li> <li><font size="3">Step 8: Press the START/STOP button once (without the brake) to turn on accessory mode again. </font></li> <li><font size="3">Step 9: Wait five seconds, then press the START/STOP button once more to power off. </font></li> <li><font size="3">Step 10: Remove the second key from the slot. </font></li> <li><font size="3">Step 11: Wait five seconds, then insert the unprogrammed smart key into the backup slot. </font></li> <li><font size="3">Step 12: Press the START/STOP button once. If successful, the vehicle will recognize and program the new smart key.</font></li> <li><font size="3"> Step 13: With the new key still in the slot, press the brake pedal, then press the START/STOP button to ensure the vehicle starts. </font></li> <li><font size="3">Step 14: Test the remote’s lock, unlock, and remote start (if equipped) functions to verify successful programming. </font></li> <li><font size="3">Step 15: If programming was unsuccessful, remove the key, wait 10 seconds, and repeat steps 1 through 14.</font></li> </ul>
