<h1>2021 Land Rover Discovery Sport – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Note:</b> The 2021 Land Rover Discovery Sport does not support onboard programming for keyless entry remote fobs. Programming requires specialized diagnostic equipment to interface with the vehicle’s keyless entry and security systems.</font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b></font></p> <ul> <li><font size="3">Step 1: Ensure the replacement smart key remote fob is compatible with the 2021 Land Rover Discovery Sport, including the correct part number and frequency specifications.</font></li> <li><font size="3">Step 2: Confirm that the vehicle’s battery is fully charged and that all doors, the trunk, and the hood are closed to avoid interruptions during programming.</font></li> <li><font size="3">Step 3: Use an appropriate professional diagnostic tool (such as Land Rover’s approved diagnostic system or equivalent) to connect to the OBD-II port, located beneath the dashboard on the driver’s side. This tool will communicate with the vehicle’s Body Control Module (BCM) and keyless entry system.</font></li> <li><font size="3">Step 4: Navigate to the Body Control Module (BCM) or Keyless Entry section using the diagnostic tool and begin the programming process.</font></li> <li><font size="3">Step 5: Follow the on-screen instructions on the diagnostic tool to program the new smart key remote fob. You may need to insert the original key or fob into the ignition or press specific buttons on the remote to confirm the programming.</font></li> <li><font size="3">Step 6: If additional remotes need to be programmed, repeat the process for each one during the same session. All remotes must be programmed at the same time, as any unprogrammed remotes will no longer function.</font></li> <li><font size="3">Step 7: Once all remotes are successfully programmed, follow the diagnostic tool’s instructions to exit programming mode. Disconnect the diagnostic tool from the OBD-II port.</font></li> <li><font size="3">Step 8: Test each programmed remote to ensure proper operation of functions such as lock, unlock, remote start, and panic.</font></li> </ul>
