<h1>2022 GMC Acadia – Smart Key Fob Registration Process</h1> <p><font size="3"><b>System Type:</b> Intelligent Access Smart Key </font></p> <p><font size="3"><b>Programming Option 1:</b> Adding Remotes with Two Recognized Fobs </font></p> <ul> <li><font size="3">Step 1: Make sure the vehicle is turned off. </font></li> <li><font size="3">Step 2: Place both recognized remotes into the front cup holders. </font></li> <li><font size="3">Step 3: Remove the keyhole cap from the driver-side exterior door handle. </font></li> <li><font size="3">Step 4: Use the mechanical key from the new remote to turn the door lock counterclockwise five times in rapid succession. </font></li> <li><font size="3">Step 5: Wait for “READY FOR REMOTE” to appear on the dashboard. </font></li> <li><font size="3">Step 6: Lift the liner inside the center console to locate the transmitter pocket and place the new remote inside. </font></li> <li><font size="3">Step 7: Press the ENGINE START/STOP button. The system will confirm that the remote has been added. </font></li> <li><font size="3">Step 8: Remove the remote and press either the LOCK or UNLOCK button to complete pairing. </font></li> <li><font size="3">Step 9: Repeat Steps 6–8 for any additional remotes. </font></li> <li><font size="3">Step 10: Press and hold the ENGINE START/STOP button for 12 seconds to exit programming mode. </font></li> <li><font size="3">Step 11: Reinsert the mechanical key into the fob. </font></li> </ul> <p><font size="3"><b>Programming Option 2:</b> With No Recognized Remotes </font></p> <ul> <li><font size="3">Step 1: Insert the mechanical key into the driver’s door lock and turn it to unlock five times within 10 seconds. </font></li> <li><font size="3">Step 2: The message “REMOTE LEARN PENDING” will appear. Wait for the next prompt. </font></li> <li><font size="3">Step 3: When prompted, press the ENGINE START/STOP button. </font></li> <li><font size="3">Step 4: Repeat the 10-minute wait and press sequence two more times (three total cycles). </font></li> <li><font size="3">Step 5: After the third cycle, insert the new remote into the center console transmitter pocket. </font></li> <li><font size="3">Step 6: Press the ENGINE START/STOP button to register the remote. </font></li> <li><font size="3">Step 7: Remove the remote and press the LOCK or UNLOCK button. </font></li> <li><font size="3">Step 8: Repeat for additional remotes. </font></li> <li><font size="3">Step 9: Press and hold the ENGINE START/STOP button for 12 seconds to exit programming. </font></li> <li><font size="3">Step 10: Return the mechanical key to the fob shell.</font></li> </ul>
