<h1>2022 Land Rover Defender Keyless Entry Remote Fob (Smart Key)</h1> <p><font size="3"><b>Important Note:</b> The 2022 Land Rover Defender is not equipped with onboard programming capabilities for smart key remote fobs. Programming requires the use of specialized diagnostic tools.</font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b></font></p> <ul> <li><font size="3">Step 1: Prepare the Vehicle Ensure the ignition is off and the vehicle is securely in “Park.” Open the driver’s door and leave it open throughout the procedure. All other doors should remain closed.</font></li> <li><font size="3">Step 2: Connect Diagnostic Equipment Plug a compatible key programming device into the vehicle’s OBD-II port (located below the dashboard). Power on the tool and select the appropriate vehicle model and year from the menu.</font></li> <li><font size="3">Step 3: Access the Programming Interface Navigate to the key or immobilizer programming section within the tool’s software. Authenticate access using the required security procedures (e.g., PIN verification or security wait time).</font></li> <li><font size="3">Step 4: Begin Smart Key Pairing Place the new smart key fob inside the designated detection area (commonly near the start button or within the center console compartment). Follow prompts on the programming tool to initiate synchronization with the vehicle.</font></li> <li><font size="3">Step 5: Add Additional Remotes (Optional) If programming more than one remote, repeat the pairing process for each additional fob during the same session. Ensure that all remotes you wish to use are present, as the system may erase any unrecognized keys.</font></li> <li><font size="3">Step 6: Verify Remote Functions After successful programming, test each key fob to confirm functionality: Lock and unlock doors Remote start or push-to-start ignition Trunk/hatch control Proximity unlocking (if equipped)</font></li> <li><font size="3">Step 7: Complete the Process Safely exit the programming session using the diagnostic tool. Disconnect the device from the OBD-II port. Close the driver’s door to finish the procedure.</font></li> </ul> <p><font size="3"><b>Additional Notes:</b></font></p> <ul> <li><font size="3">Ensure key fob batteries are in good condition before starting. Only use genuine or fully compatible fobs designed for the 2022 Defender. Complete the entire procedure without unnecessary delays to avoid timeout.</font></li> </ul>
