2023 Buick Encore GX

2023 Smart Keyless Entry Remote Fob – Encore GX

Programming with Two Recognized Remote Keys: Use this procedure when two functioning remote keys are already paired with the vehicle. This allows you to add one or more new remotes using the vehicle’s onboard system.

  • Step 1: Ensure the vehicle is turned off and safely parked.
  • Step 2: Place the two recognized remote keys into the remote key pocket inside the vehicle (location may vary by trim—typically in the center console).
  • Step 3: Go to the driver’s exterior door and remove the cap from the key lock cylinder.
  • Step 4: Insert the emergency key from the new remote into the driver’s side lock.
  • Step 5: Turn the key to the unlock position (counterclockwise) five times within 10 seconds.
  • Step 6: The Driver Information Center (DIC) should display: “READY FOR REMOTE #2,” “#3,” “#4,” etc.
  • Step 7: Remove the two recognized remotes from the remote pocket.
  • Step 8: Place the new remote into the remote pocket.
  • Step 9: Press the ENGINE START/STOP button once.
  • Step 10: Wait for confirmation on the display that the new remote has been successfully programmed.
  • Step 11: Remove the newly added remote and press either the LOCK or UNLOCK button to complete the pairing.
  • Step 12: Repeat Steps 8 through 11 to add more remotes, if needed.
  • Step 13: Once programming is complete, press and hold the ENGINE START/STOP button for 12 seconds to exit programming mode.
  • Step 14: Reinsert the emergency key into the remote.
  • Step 15: Replace the key lock cylinder cap on the driver’s door handle.

Programming Without Any Recognized Remote Keys: Use this procedure if you do not have any programmed remotes. This process allows you to program up to eight new remotes and takes about 30 minutes. This method may not be supported in all regions.

  • Step 1: Ensure the vehicle is turned off and that you have all new remotes ready.
  • Step 2: Remove the key lock cylinder cap from the driver’s exterior door handle.
  • Step 3: Insert the emergency key into the door lock and turn it to the unlock position (counterclockwise) five times within 10 seconds.
  • Step 4: The DIC will display: “REMOTE LEARN PENDING, PLEASE WAIT.”
  • Step 5: Wait approximately 10 minutes until the display changes to: “PRESS ENGINE START BUTTON TO LEARN.”
  • Step 6: Press the ENGINE START/STOP button once.
  • Step 7: The DIC will display “REMOTE LEARN PENDING, PLEASE WAIT” again.
  • Step 8: Repeat Steps 5 through 7 two more times, for a total of three 10-minute cycles.
  • Step 9: After the third cycle, the display will show: “READY FOR REMOTE #1.”
  • Step 10: Place the first new remote into the remote key pocket.
  • Step 11: Press the ENGINE START/STOP button once.
  • Step 12: Wait for the DIC to confirm the remote has been learned.
  • Step 13: Remove the remote and press LOCK or UNLOCK to complete registration.
  • Step 14: To add more remotes, repeat Steps 10 through 13.
  • Step 15: When all desired remotes are programmed, press and hold the ENGINE START/STOP button for 12 seconds to exit programming mode.
  • Step 16: Reinsert the emergency key into each remote.
  • Step 17: Replace the driver’s door lock cylinder cap.