<h1>2023 Land Rover Defender Keyless Entry Remote Fob (Smart Key)</h1> <p><font size="3"><b>Important Note:</b> The 2023 Land Rover Defender does not support onboard programming for smart key remote fobs. All programming must be completed using manufacturer-grade diagnostic equipment.</font></p> <p><font size="3"><b>Step-by-Step Smart Key Programming Instructions:</b></font></p> <ul> <li><font size="3">Step 1: Prepare the Vehicle Make sure the vehicle is parked securely and the ignition is off. Open the driver’s door and leave it open. Ensure all other doors remain closed.</font></li> <li><font size="3">Step 2: Connect Diagnostic Equipment Plug a compatible programming device into the OBD-II port, typically located beneath the dashboard on the driver’s side. Power on the tool and choose the vehicle’s make, model, and year from the interface.</font></li> <li><font size="3">Step 3: Enter Key Programming Mode Using the programming tool, navigate to the immobilizer or key programming section. Authenticate access to the system by following on-screen instructions, which may involve security code entry or confirmation.</font></li> <li><font size="3">Step 4: Pair the New Smart Key Fob Place the new fob inside the vehicle’s programming detection zone (usually the center console or near the start button). Begin the key pairing process using the prompts on the programming tool. Wait for confirmation that the key has been accepted.</font></li> <li><font size="3">Step 5: Add Additional Keys (If Needed) Repeat the pairing steps for each additional remote you wish to program during this session. Ensure all keys are present, as any not included in this session may be deactivated.</font></li> <li><font size="3">Step 6: Confirm Smart Key Functionality Test the newly programmed remote(s): Lock and unlock the doors Start the engine using the push-to-start system Check trunk access and proximity functions (if applicable)</font></li> <li><font size="3">Step 7: Finalize the Programming Session End the session safely using the programming device menu. Disconnect the equipment from the OBD-II port. Close the driver’s door to exit programming mode.</font></li> </ul> <p><font size="3"><b>Additional Tips:</b></font></p> <ul> <li><font size="3">Ensure the fob has a fresh battery before beginning. Only use compatible, unprogrammed smart key remotes for this process. Complete all steps promptly to prevent timeout from the vehicle system.</font></li> </ul>
