<h1>2023 Land Rover Discovery – Keyless Entry Remote Fob Programming Instructions</h1> <p><font size="3"><b>Note:</b> The 2023 Land Rover Discovery does not support onboard programming for keyless entry remote fobs. Programming requires specialized diagnostic equipment to interface with the vehicle’s keyless entry and security systems.</font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b></font></p> <ul> <li><font size="3">Step 1: Verify Compatibility of the Remote Fob Ensure that the replacement smart key remote fob is compatible with the 2023 Land Rover Discovery, including the correct part number and operating frequency.</font></li> <li><font size="3">Step 2: Prepare the Vehicle Confirm that the vehicle’s battery is fully charged and in optimal condition. Close all doors, the trunk, and the hood to prevent any interruptions during programming.</font></li> <li><font size="3">Step 3: Connect to the Vehicle’s OBD-II Port Use a professional diagnostic tool (such as Land Rover’s approved diagnostic system or equivalent) to connect to the OBD-II port, located beneath the dashboard on the driver’s side. This tool will communicate with the vehicle’s Body Control Module (BCM) and keyless entry system.</font></li> <li><font size="3">Step 4: Access the Keyless Entry System Using the diagnostic tool, navigate to the Body Control Module (BCM) or Keyless Entry section. Follow the on-screen prompts to begin the programming process.</font></li> <li><font size="3">Step 5: Start the Smart Key Programming Process Follow the prompts on the diagnostic tool to program the new smart key remote fob. You may be asked to insert the original key or fob into the ignition or press specific buttons on the remote to confirm the programming.</font></li> <li><font size="3">Step 6: Program Additional Remotes (if applicable) If there are additional remotes to be programmed, repeat the process for each one during the same session. Ensure all remotes are programmed at the same time, as any unprogrammed remotes will no longer function.</font></li> <li><font size="3">Step 7: Exit Programming Mode Once all remotes have been successfully programmed, follow the diagnostic tool’s instructions to exit the programming mode. Disconnect the diagnostic tool from the OBD-II port.</font></li> <li><font size="3">Step 8: Test All Programmed Remotes Test each remote fob to ensure proper operation of functions like lock, unlock, remote start, and panic.</font></li> </ul>
