<h1>2024 Audi TT Remote Key Fob (Smart Key)</h1> <p><font size="3"><b>Important Information:</b> The 2024 Audi TT does not support onboard or manual programming for smart key fobs. All programming must be completed using manufacturer-approved diagnostic equipment. </font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b> </font></p> <ul> <li><font size="3">Step 1: Verify the Smart Key Ensure the new remote fob is compatible with the 2024 Audi TT and has not been previously paired with another vehicle. Only new, unprogrammed fobs or those that have been professionally reset can be reused. </font></li> <li><font size="3">Step 2: Prepare the Vehicle Confirm that the ignition is off and the vehicle is in Park. Keep the driver’s door open and ensure all other doors are closed. Check that the vehicle’s battery is fully charged to prevent interruptions. Install a fresh battery in the new key fob before starting. </font></li> <li><font size="3">Step 3: Connect to Diagnostic Equipment Insert a certified diagnostic tool (e.g., ODIS or VCDS) into the OBD-II port, located beneath the driver’s side dashboard. Launch the software and allow it to communicate with the vehicle’s control modules. </font></li> <li><font size="3">Step 4: Access the Key Programming Interface Navigate to the Key Learning or Immobilizer section within the software. Authenticate with required credentials or security codes if prompted. Select the option to add or program new keys. </font></li> <li><font size="3">Step 5: Program the Smart Key Follow the on-screen prompts to place the smart key in the vehicle’s recognition zone—typically near the center console or push-button start. The system will begin syncing the new key with the vehicle’s memory. </font></li> <li><font size="3">Step 6: Program Additional Keys (If Needed) If programming more than one fob, repeat the process while the system is still in programming mode. The system generally allows up to eight total smart keys. </font></li> <li><font size="3">Step 7: Confirm Successful Programming Once programming is complete, test the newly paired key fob to confirm it: Locks and unlocks the doors Opens the trunk Starts the engine with push-button ignition Enables keyless entry features (if equipped) </font></li> <li><font size="3">Step 8: Finalize and Exit Exit the programming mode through the software. Disconnect the diagnostic tool. Verify that all programmed keys operate correctly and that removed keys no longer function (if any were deleted). </font></li> </ul> <p><font size="3"><b>Important Notes:</b> </font></p> <p><font size="3">The programming process must be performed in one uninterrupted session. All existing keys may need to be present during programming to remain active. If the vehicle fails to enter programming mode, restart the process from Step 2.</font></p>
