<h1>2024 Land Rover Defender Keyless Entry Remote Fob (Smart Key)</h1> <p><font size="3"><b>Important Notice:</b> The 2024 Land Rover Defender does not support onboard programming for smart key fobs. Programming requires manufacturer-specific diagnostic tools capable of communicating with the vehicle's immobilizer system.</font></p> <p><font size="3"><b>Step-by-Step Programming Instructions:</b></font></p> <ul> <li><font size="3">Step 1: Prepare the Vehicle Park the vehicle on a level surface and switch the ignition to the OFF position. Open the driver’s door and leave it open. Ensure that all other doors are closed and the vehicle is not in sleep mode.</font></li> <li><font size="3">Step 2: Connect the Diagnostic Equipment Locate the OBD-II diagnostic port beneath the driver’s side dashboard. Connect an authorized programming interface capable of handling Land Rover key systems. Power on the device and select the appropriate model year and system.</font></li> <li><font size="3">Step 3: Initiate Key Programming Mode Navigate to the “Key Programming” section within the diagnostic tool. Follow the prompts to initiate secure access to the vehicle's Body Control Module (BCM) or Immobilizer system. You may be required to enter a vehicle-specific PIN or perform a verification step.</font></li> <li><font size="3">Step 4: Insert or Position the New Key Fob Depending on the system type, you may need to insert the new fob into a dedicated slot or place it within the vehicle’s interior (typically near the center console). The system will detect the new fob once it's properly positioned.</font></li> <li><font size="3">Step 5: Program the New Smart Key Follow the on-screen instructions to pair the new smart key with the vehicle. Wait for confirmation that the key has been successfully added to the system.</font></li> <li><font size="3">Step 6: Program Additional Remotes (Optional) If you have additional remotes, repeat Step 5 for each unit. It is recommended to program all keys at once, as any keys not present during programming may be erased from memory.</font></li> <li><font size="3">Step 7: Verify Functionality Test all key features: Lock and unlock functions Push-to-start ignition Trunk release Passive entry (if equipped)</font></li> <li><font size="3">Step 8: Finalize the Session Safely exit programming mode using the diagnostic tool. Disconnect the programming equipment from the OBD-II port. Close the driver’s door to complete the process.</font></li> </ul> <p><font size="3"><b>Tips for Success:</b></font></p> <ul> <li><font size="3">Use only brand-new, compatible smart keys not previously programmed to another vehicle. Replace the battery in the smart key if programming fails or is intermittent. Avoid interrupting the vehicle’s power supply during the process.</font></li> </ul>
