<h1>2024 Lincoln Navigator – Smart Key Fob Programming Instructions</h1> <p><font size="3"><b>System Type:</b> Intelligent Access Smart Key (Push-Button Start) </font></p> <p><font size="3"><b>Requirements:</b> Two currently programmed key fobs and one new unprogrammed fob </font></p> <p><b><font size="3">Before You Begin: </font></b><font size="3">Ensure the vehicle is completely turned off. All doors must be fully closed and remain closed throughout the procedure. Have all three remotes (two programmed and one new) within reach. Complete the entire sequence within 30 seconds. If any step is missed or delayed, wait at least one minute before attempting the process again. Carefully review all steps before starting. </font></p> <p><font size="3"><b>Programming Steps:</b> </font></p> <ul> <li><font size="3">Step 1: Open the center console and locate the backup slot. Insert the first programmed key fob into the slot. </font></li> <li><font size="3">Step 2: Without pressing the brake pedal, press the START/STOP button once to turn on the ignition electronics (accessory mode). </font></li> <li><font size="3">Step 3: Wait exactly five seconds, then press the START/STOP button again to turn the electronics off. Remove the first remote from the slot. </font></li> <li><font size="3">Step 4: Within 10 seconds, place the second programmed fob into the backup slot. Press the START/STOP button again. </font></li> <li><font size="3">Step 5: After another 5-second pause, press the button once more. Allow the system to remain on for at least 3 seconds but no longer than 10 seconds. </font></li> <li><font size="3">Step 6: Turn the system off by pressing the START/STOP button once more, and remove the second fob. </font></li> <li><font size="3">Step 7: Immediately insert the new, unprogrammed smart key into the same slot. Press and release the START/STOP button. </font></li> <li><font size="3">Step 8: The instrument cluster should display a confirmation message indicating that the new key has been successfully added. You may also hear the horn chirp and see the hazard lights flash briefly. </font></li> <li><font size="3">Step 9: To confirm the process, press the brake pedal and then press the START/STOP button to start the vehicle. Ensure the engine starts and all remote features function correctly (e.g., lock/unlock, trunk, panic). </font></li> </ul> <p><font size="3"><b>If the Process Fails:</b> </font></p> <ul> <li><font size="3">Wait 10 seconds before starting again. Begin from Step 1 and make sure the timing is followed carefully.</font></li> </ul>
